[lkml]   [2015]   [Apr]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [Linux-nvdimm] [PATCH] pmem: Add prints at module load and unload
On Thu, Apr 02, 2015 at 09:01:14AM -0700, Dan Williams wrote:
> >> If anything I think these should be dev_dbg().
> >
> > We do not have a dev at any of this point, and it does not
> > belong to any specific device.
> Ah, true this is prior to the driver attaching... that said it seems
> more relevant to print from probe() (where we do have a device) than
> init where the device may remain idle due to some other policy.
> > Also I would like this
> > _info and not _dbg so to always have it, also for production.
> > See the chatter for a single SCSI disk the minimum we need
> > is just the small print that tells all that we need (for now)
> Not sure we want to follow so closely in the footsteps of SCSI's chattiness.

Defintively not! A single dev_info at ->probe time sounds ok, something

dev_info(dev, "registering region [0x%pa:0x%zx]\n",
&pmem->phys_addr, pmem->size);

but there are plenty other drivers not that chatty, e.g. virtio and we're
doing just fine for them.

 \ /
  Last update: 2015-04-02 19:21    [W:0.065 / U:0.308 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site