lkml.org 
[lkml]   [2015]   [Mar]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 5/5] drm/msm/mdp5: Add hardware configuration for msm8x16


On 03/14/2015 01:15 AM, "Stéphane Viau" wrote:
> Hi,
>
>> Hi,
>>
>> On 03/09/2015 06:41 PM, Stephane Viau wrote:
>>> This change adds the hw configuration for msm8x16 chipsets in
>>> mdp5_cfg module.
>>>
>>> Note that only one external display interface is present in this
>>> configuration (DSI) but has not been enabled yet. It will be enabled
>>> once drm/msm driver supports DSI connectors.
>>>
>>> Signed-off-by: Stephane Viau <sviau@codeaurora.org>
>>> ---
>>> drivers/gpu/drm/msm/mdp/mdp5/mdp5_cfg.c | 51
>>> ++++++++++++++++++++++++++++++++-
>>> 1 file changed, 50 insertions(+), 1 deletion(-)
>>>
>>> diff --git a/drivers/gpu/drm/msm/mdp/mdp5/mdp5_cfg.c
>>> b/drivers/gpu/drm/msm/mdp/mdp5/mdp5_cfg.c
>>> index 96ea6dd..9ff7ac1 100644
>>> --- a/drivers/gpu/drm/msm/mdp/mdp5/mdp5_cfg.c
>>> +++ b/drivers/gpu/drm/msm/mdp/mdp5/mdp5_cfg.c
>>> @@ -1,5 +1,5 @@
>>> /*
>>> - * Copyright (c) 2014 The Linux Foundation. All rights reserved.
>>> + * Copyright (c) 2014-2015 The Linux Foundation. All rights reserved.
>>> *
>>> * This program is free software; you can redistribute it and/or
>>> modify
>>> * it under the terms of the GNU General Public License version 2 and
>>> @@ -150,10 +150,59 @@ const struct mdp5_cfg_hw apq8084_config = {
>>> .max_clk = 320000000,
>>> };
>>>
>>> +const struct mdp5_cfg_hw msm8x16_config = {
>>> + .name = "msm8x16",
>>> + .mdp = {
>>> + .count = 1,
>>> + .base = { 0x01000 },
>>> + },
>>> + .smp = {
>>> + .mmb_count = 8,
>>> + .mmb_size = 8192,
>>> + .clients = {
>>> + [SSPP_VIG0] = 1, [SSPP_DMA0] = 4,
>>> + [SSPP_RGB0] = 7, [SSPP_RGB1] = 8,
>>> + },
>>> + },
>>> + .ctl = {
>>> + .count = 5,
>>> + .base = { 0x02000, 0x02200, 0x02400, 0x02600, 0x02800 },
>>> + },
>>> + .pipe_vig = {
>>> + .count = 1,
>>> + .base = { 0x05000 },
>>> + },
>>> + .pipe_rgb = {
>>> + .count = 2,
>>> + .base = { 0x15000, 0x17000 },
>>> + },
>>> + .pipe_dma = {
>>> + .count = 1,
>>> + .base = { 0x25000 },
>>> + },
>>> + .lm = {
>>> + .count = 2, /* LM0 and LM3 */
>>> + .base = { 0x45000, 0x48000 },
>>> + .nb_stages = 5,
>>> + },
>>> + .dspp = {
>>> + .count = 1,
>>> + .base = { 0x55000 },
>>> +
>>> + },
>>> + .intf = {
>>> + .count = 1, /* INTF_1 */
>>> + .base = { 0x6B800 },
>>
>> We would need to put the other non-existent INTF_0, INTF_2 and INTF_3
>> base addresses here too, so that the writes to
>> REG_MDP5_INTF_TIMING_ENGINE_EN in the patch "Make the intf connection in
>> config module" access the correct registers.
>
> You are referring here to the discussion we had in "drm/msm/mdp5: Make the
> intf connection in config module"[1]...
>
> Let me clarify:
> We see these faults when interfaces are *present* but not *supported* by
> the driver, where:
> - *present* means that the interfaces are physically implemented in HW
> and therefore need to be reflected by "intf.base" addresses
> - *supported* means that the msm KMS driver is actually able to drive an
> interface
> If you look at mdp5_cfg.c in "drm/msm/mdp5: Make the intf connection in
> config module"[1], 4 interfaces (intf.base) are present (for apq8084), but
> only 2 are supported (intfs[])...
> What I meant is that even though our driver cannot support all interfaces
> present in a chip, we still need to disable them in mdp5_kms_init().
> (BTW, this is probably due to my bootloader enabling the DSI whereas the
> msm KMS driver does not support it as of yet - and thus leads to
> artifacts/underflow on my eDP panel.)

Okay, I get it now. I think I wasn't sure about whether INTF_DISABLED
represents *present* or *supported*. Thanks for the clarification.

>
> So to answer your comment, it doesn't make too much sense to define base
> addresses for interfaces that are not present in a chip. Instead I'd
> prefer to check if intf.base is not NULL before writing in
> REG_MDP5_INTF_TIMING_ENGINE_EN registers.. and avoid some INVALID_INDEX
> BUGs ;-).

That sounds good. Thanks.

Archit

--
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project


\
 
 \ /
  Last update: 2015-03-16 06:21    [W:0.082 / U:1.920 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site