lkml.org 
[lkml]   [2015]   [Mar]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH 5/5] drm/msm/mdp5: Add hardware configuration for msm8x16
From
Hi,

> Hi,
>
> On 03/09/2015 06:41 PM, Stephane Viau wrote:
>> This change adds the hw configuration for msm8x16 chipsets in
>> mdp5_cfg module.
>>
>> Note that only one external display interface is present in this
>> configuration (DSI) but has not been enabled yet. It will be enabled
>> once drm/msm driver supports DSI connectors.
>>
>> Signed-off-by: Stephane Viau <sviau@codeaurora.org>
>> ---
>> drivers/gpu/drm/msm/mdp/mdp5/mdp5_cfg.c | 51
>> ++++++++++++++++++++++++++++++++-
>> 1 file changed, 50 insertions(+), 1 deletion(-)
>>
>> diff --git a/drivers/gpu/drm/msm/mdp/mdp5/mdp5_cfg.c
>> b/drivers/gpu/drm/msm/mdp/mdp5/mdp5_cfg.c
>> index 96ea6dd..9ff7ac1 100644
>> --- a/drivers/gpu/drm/msm/mdp/mdp5/mdp5_cfg.c
>> +++ b/drivers/gpu/drm/msm/mdp/mdp5/mdp5_cfg.c
>> @@ -1,5 +1,5 @@
>> /*
>> - * Copyright (c) 2014 The Linux Foundation. All rights reserved.
>> + * Copyright (c) 2014-2015 The Linux Foundation. All rights reserved.
>> *
>> * This program is free software; you can redistribute it and/or
>> modify
>> * it under the terms of the GNU General Public License version 2 and
>> @@ -150,10 +150,59 @@ const struct mdp5_cfg_hw apq8084_config = {
>> .max_clk = 320000000,
>> };
>>
>> +const struct mdp5_cfg_hw msm8x16_config = {
>> + .name = "msm8x16",
>> + .mdp = {
>> + .count = 1,
>> + .base = { 0x01000 },
>> + },
>> + .smp = {
>> + .mmb_count = 8,
>> + .mmb_size = 8192,
>> + .clients = {
>> + [SSPP_VIG0] = 1, [SSPP_DMA0] = 4,
>> + [SSPP_RGB0] = 7, [SSPP_RGB1] = 8,
>> + },
>> + },
>> + .ctl = {
>> + .count = 5,
>> + .base = { 0x02000, 0x02200, 0x02400, 0x02600, 0x02800 },
>> + },
>> + .pipe_vig = {
>> + .count = 1,
>> + .base = { 0x05000 },
>> + },
>> + .pipe_rgb = {
>> + .count = 2,
>> + .base = { 0x15000, 0x17000 },
>> + },
>> + .pipe_dma = {
>> + .count = 1,
>> + .base = { 0x25000 },
>> + },
>> + .lm = {
>> + .count = 2, /* LM0 and LM3 */
>> + .base = { 0x45000, 0x48000 },
>> + .nb_stages = 5,
>> + },
>> + .dspp = {
>> + .count = 1,
>> + .base = { 0x55000 },
>> +
>> + },
>> + .intf = {
>> + .count = 1, /* INTF_1 */
>> + .base = { 0x6B800 },
>
> We would need to put the other non-existent INTF_0, INTF_2 and INTF_3
> base addresses here too, so that the writes to
> REG_MDP5_INTF_TIMING_ENGINE_EN in the patch "Make the intf connection in
> config module" access the correct registers.

You are referring here to the discussion we had in "drm/msm/mdp5: Make the
intf connection in config module"[1]...

Let me clarify:
We see these faults when interfaces are *present* but not *supported* by
the driver, where:
- *present* means that the interfaces are physically implemented in HW
and therefore need to be reflected by "intf.base" addresses
- *supported* means that the msm KMS driver is actually able to drive an
interface
If you look at mdp5_cfg.c in "drm/msm/mdp5: Make the intf connection in
config module"[1], 4 interfaces (intf.base) are present (for apq8084), but
only 2 are supported (intfs[])...
What I meant is that even though our driver cannot support all interfaces
present in a chip, we still need to disable them in mdp5_kms_init().
(BTW, this is probably due to my bootloader enabling the DSI whereas the
msm KMS driver does not support it as of yet - and thus leads to
artifacts/underflow on my eDP panel.)

So to answer your comment, it doesn't make too much sense to define base
addresses for interfaces that are not present in a chip. Instead I'd
prefer to check if intf.base is not NULL before writing in
REG_MDP5_INTF_TIMING_ENGINE_EN registers.. and avoid some INVALID_INDEX
BUGs ;-).

I'm sending out a v3 for "drm/msm/mdp5: Make the intf connection in config
module" in a minute...

[1] http://lists.freedesktop.org/archives/dri-devel/2015-March/078651.html

>
> Archit
>
>> + },
>> + /* TODO enable .intfs[] with [1] = INTF_DSI, once DSI is implemented
>> */
>> + .max_clk = 320000000,
>> +};
>> +
>> static const struct mdp5_cfg_handler cfg_handlers[] = {
>> { .revision = 0, .config = { .hw = &msm8x74_config } },
>> { .revision = 2, .config = { .hw = &msm8x74_config } },
>> { .revision = 3, .config = { .hw = &apq8084_config } },
>> + { .revision = 6, .config = { .hw = &msm8x16_config } },
>> };
>>
>>
>>
>
> --
> Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
> a Linux Foundation Collaborative Project
> --
> To unsubscribe from this list: send the line "unsubscribe linux-arm-msm"
> in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at http://vger.kernel.org/majordomo-info.html
>


--
Qualcomm Innovation Center, Inc.

The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project



\
 
 \ /
  Last update: 2015-03-13 21:01    [W:0.077 / U:0.244 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site