[lkml]   [2015]   [Feb]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH 0/8] Add proper support for Compulab CM-A510/SBC-A510
On 02/26/2015 12:39 PM, Sebastian Hesselbarth wrote:
> On 26.02.2015 18:55, Gregory CLEMENT wrote:
>> On 17/02/2015 19:52, Sebastian Hesselbarth wrote:
>>> This patch set improves current mainline support for the Compulab
>>> CM-A510 System-on-Module (SoM) and its default Compulab SBC-A510
>>> base board. Thanks to Gabriel Dobato who agreed to remote debug and
>>> test the provided DT changes.
> [...]
>>> Sebastian Hesselbarth (8):
>>> i2c: mux-pinctrl: Rework to honor disabled child nodes
>>> devicetree: vendor-prefixes: Add CompuLab to known vendors
>>> ARM: dts: dove: Fix uart[23] reg property
>>> ARM: dts: dove: Always include gpio and interrupt-controller headers
>>> ARM: dts: dove: Add node labels for PCIe ports 0 and 1
>>> ARM: dts: dove: Add some more common pinctrl settings
>>> ARM: dts: dove: Add internal i2c multiplexer node
>>> ARM: dts: dove: Add proper support for Compulab CM-A510/SBC-A510
>> Patches 3 to 6 applied on mvebu/dt
>> If I understood well patches 7 and 8 depend on patch 1 which had not been
>> taken yet.
> Correct. Once I get a Tested-by from Stephen, I'll resend the 4
> remaining patches.

Me? For which patch? I thought there was going to be a v2 of the i2c mux
driver patch given the comments on it, but perhaps I'm misremembering?

 \ /
  Last update: 2015-02-26 21:21    [W:0.077 / U:0.360 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site