lkml.org 
[lkml]   [2014]   [Dec]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH V2 1/2] spi: img-spfi: Increase DMA burst size
Date
A 1-byte burst size is rather inefficient and has been shown to cause
TX issues during testing. Increase the DMA burst size to 4-bytes for
both RX and TX DMA when using the 8-bit FIFO.

Signed-off-by: Andrew Bresticker <abrestic@chromium.org>
---
drivers/spi/spi-img-spfi.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/spi/spi-img-spfi.c b/drivers/spi/spi-img-spfi.c
index cd14556..aad6683 100644
--- a/drivers/spi/spi-img-spfi.c
+++ b/drivers/spi/spi-img-spfi.c
@@ -341,7 +341,7 @@ static int img_spfi_start_dma(struct spi_master *master,
default:
rxconf.src_addr = spfi->phys + SPFI_RX_8BIT_VALID_DATA;
rxconf.src_addr_width = 1;
- rxconf.src_maxburst = 1;
+ rxconf.src_maxburst = 4;
}
dmaengine_slave_config(spfi->rx_ch, &rxconf);

@@ -368,7 +368,7 @@ static int img_spfi_start_dma(struct spi_master *master,
default:
txconf.dst_addr = spfi->phys + SPFI_TX_8BIT_VALID_DATA;
txconf.dst_addr_width = 1;
- txconf.dst_maxburst = 1;
+ txconf.dst_maxburst = 4;
break;
}
dmaengine_slave_config(spfi->tx_ch, &txconf);
--
2.2.0.rc0.207.ga3a616c


\
 
 \ /
  Last update: 2014-12-22 21:01    [W:0.151 / U:0.224 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site