[lkml]   [2014]   [Dec]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Subject[PULL REQUEST] i2c for 3.19

for 3.19, the I2C subsystem has to offer special candy this time. Right
in time for Christmas :)

* I2C slave framework: finally, a generic mechanism for Linux being
an I2C slave (if the bus driver supports that). Docs are still missing
but will come later this cycle, the code is good enough to go.
* I2C muxes represent their topology in sysfs much more detailed.
This will help users to navigate around much easier.
* irq population of i2c clients is now done at probe time, not device
creation time, to have better support for deferred probing.
* new drivers for Imagination SCB, Amlogic Meson
* DMA support added for Freescale IMX, Renesas SHMobile
* slightly bigger driver updates to OMAP, i801, AT91, and rk3x
(mostly quirk handling, timing updates, and using better kernel
* eeprom driver can now write with byte-access (very slow, but OK to
* and the bunch of smaller fixes, cleanups, ID updates...

Plese pull!



The following changes since commit 206c5f60a3d902bc4b56dab2de3e88de5eb06108:

Linux 3.18-rc4 (2014-11-09 14:55:29 -0800)

are available in the git repository at:

git:// i2c/for-3.19

for you to fetch changes up to 6cf710d47633be388e831713738626d1911163c8:

i2c: sh_mobile: remove unneeded DMA mask (2014-12-11 22:28:22 +0100)

Alexander Kochetkov (5):
i2c: omap: cleanup register definitions
i2c: omap: implement workaround for handling invalid BB-bit values
i2c: omap: don't reset controller if Arbitration Lost detected
i2c: omap: add notes related to i2c multimaster mode
omap: i2c: don't check bus state IP rev3.3 and earlier

Andrew Bresticker (1):
i2c: img-scb: Allow building for MIPS

Arnd Bergmann (1):
i2c: at91: remove legacy DMA support

Beniamino Galvani (1):
i2c: add support for Amlogic Meson I2C controller

Christian Gmeiner (1):
eeprom: at24: extend driver to allow writing via i2c_smbus_write_byte_data

Danielle Costantino (1):
i2c: mpc: report correct I2C error return codes

Devin Ryles (1):
i2c: i801: Add DeviceIDs for SunrisePoint LP

Doug Anderson (1):
i2c: designware: Fix falling time bindings doc

Fabio Estevam (1):
i2c: imx+mxs: Use the preferred form for passing a size of a struct

Geert Uytterhoeven (5):
i2c: sh_mobile: Document SoC-specific bindings
i2c: sh_mobile: Add support for r8a73a4 and sh73a0
i2c: core: Fix probing of i2c slaves without interrupts
DT: i2c: Add more devices handled by the rtc-rs5c372 driver
DT: i2c: Add more devices handled by the adxl34x-i2c driver

Gerlando Falauto (1):
i2c: mux: create "channel-n" symlinks for child segments in the mux device

Grygorii Strashko (1):
i2c: davinci: switch to use platform_get_irq

James Hogan (2):
DT: i2c: Add binding document for IMG I2C SCB
i2c: img-scb: Add Imagination Technologies I2C SCB driver

Jean Delvare (4):
i2c: i801: Use wait_event_timeout to wait for interrupts
i2c: i801: Fallback to polling if request_irq() fails
i2c: i801: Check if interrupts are disabled
i2c: i801: Drop useless debug message

Lars-Peter Clausen (1):
Documentation: i2c: Use PM ops instead of legacy suspend/resume

Laurent Pinchart (2):
of/irq: Export of_irq_get()
i2c: core: Map OF IRQ at probe time

Ludovic Desroches (1):
i2c: at91: enable probe deferring on dma channel request

Max Schwarz (2):
i2c: rk3x: handle dynamic clock rate changes correctly
i2c: rk3x: add Kconfig dependency on COMMON_CLK

Mike Looijmans (1):
i2c: davinci: don't use interruptible completion

Pankaj Dubey (1):
i2c: s3c2410: Handle i2c sys_cfg register in i2c driver

Petr Cvek (1):
i2c: pxa: add support for SCCB devices

Thomas Gessler (1):
i2c: xiic: Fix big-endian register access

Wenyou Yang (3):
i2c: at91: add support for runtime PM
i2c: at91: add support for system PM
i2c: at91: adopt pinctrl support

Wolfram Sang (14):
i2c: exynos5: use proper errno for timeout
i2c: sh_mobile: sort includes alphabetically
i2c: sh_mobile: add DMA support
i2c: sh_mobile: improve success message
i2c: acpi: remove unneeded variable initialization
i2c: mux: create symlink to actual mux device
i2c: imx: simplify i2c_imx_dma_write() a little
i2c: sh_mobile: use proper device for mapping DMA memory
i2c: sh_mobile: optimize irq entry
MAINTAINERS: add I2C dt bindings also to I2C realm
i2c: core changes for slave support
i2c: slave-eeprom: add eeprom simulator driver
i2c: rcar: add slave support
i2c: sh_mobile: remove unneeded DMA mask

Yao Yuan (2):
i2c: imx: Sort include headers alphabetically
i2c: imx: add DMA support for freescale i2c driver

addy ke (1):
i2c: rk3x: adjust the LOW divison based on characteristics of SCL

.../devicetree/bindings/i2c/i2c-designware.txt | 4 +-
.../devicetree/bindings/i2c/i2c-img-scb.txt | 26 +
Documentation/devicetree/bindings/i2c/i2c-imx.txt | 11 +
.../devicetree/bindings/i2c/i2c-meson.txt | 24 +
.../devicetree/bindings/i2c/i2c-sh_mobile.txt | 14 +
.../devicetree/bindings/i2c/trivial-devices.txt | 8 +
Documentation/i2c/busses/i2c-i801 | 1 +
Documentation/i2c/upgrading-clients | 6 +-
Documentation/i2c/writing-clients | 8 +-
drivers/i2c/Kconfig | 10 +
drivers/i2c/Makefile | 1 +
drivers/i2c/busses/Kconfig | 20 +-
drivers/i2c/busses/Makefile | 2 +
drivers/i2c/busses/i2c-at91.c | 127 +-
drivers/i2c/busses/i2c-davinci.c | 24 +-
drivers/i2c/busses/i2c-exynos5.c | 4 +-
drivers/i2c/busses/i2c-i801.c | 57 +-
drivers/i2c/busses/i2c-img-scb.c | 1412 ++++++++++++++++++++
drivers/i2c/busses/i2c-imx.c | 354 ++++-
drivers/i2c/busses/i2c-meson.c | 492 +++++++
drivers/i2c/busses/i2c-mpc.c | 18 +-
drivers/i2c/busses/i2c-mxs.c | 2 +-
drivers/i2c/busses/i2c-omap.c | 133 +-
drivers/i2c/busses/i2c-pxa.c | 19 +-
drivers/i2c/busses/i2c-rcar.c | 124 +-
drivers/i2c/busses/i2c-rk3x.c | 251 +++-
drivers/i2c/busses/i2c-s3c2410.c | 29 +
drivers/i2c/busses/i2c-sh_mobile.c | 244 +++-
drivers/i2c/busses/i2c-xiic.c | 58 +-
drivers/i2c/i2c-core.c | 64 +-
drivers/i2c/i2c-mux.c | 12 +
drivers/i2c/i2c-slave-eeprom.c | 170 +++
drivers/misc/eeprom/at24.c | 35 +-
drivers/of/irq.c | 1 +
include/linux/i2c.h | 29 +
36 files changed, 3608 insertions(+), 187 deletions(-)
create mode 100644 Documentation/devicetree/bindings/i2c/i2c-img-scb.txt
create mode 100644 Documentation/devicetree/bindings/i2c/i2c-meson.txt
create mode 100644 drivers/i2c/busses/i2c-img-scb.c
create mode 100644 drivers/i2c/busses/i2c-meson.c
create mode 100644 drivers/i2c/i2c-slave-eeprom.c
[unhandled content-type:application/pgp-signature]
 \ /
  Last update: 2014-12-14 15:21    [W:0.033 / U:0.016 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site